HP 5900 series - Igmp-Snooping Static-Group

Examples
le IGMP snooping, and configure 10.1.1.1 as the source IP address of IGMP
igmp-snooping
oping enable
al-query source-ip 10.1.1.1
-snooping static-group
Use undo igmp-snooping static-group to remove a static group member.
Syntax
igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
-address ] vlan vlan-id | all }
tatic group member of multicast groups.
Predefine
Paramete
dress in the range of 224.0.1.0 to
pecifies a multicast source by its IP address. If you specify a multicast source,
ommand configures the port as a static group member for a multicast source and group. If you do
t specify a multicast source, the command configures the port as a static group member for a multicast
by its VLAN ID in the range of 1 to 4094.
Examples
abitEthernet 1/0/1 as a static group member of the multicast source and group
g
# In VLAN 2, enab
group-specific queries.
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-sno
[Sysname-vlan2] igmp-snooping speci
Related commands
• enable (IGMP-snooping view)
• igmp-snooping enable
igmp
Use igmp-snooping static-group to configure a port as a static group member of a multicast group.
undo igmp-snooping static-group { group-address [ source-ip source
Default
A port is not a s
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
d user roles
network-admin
rs
group-address: Specifies a multicast group by its IP ad
239.255.255.255.
source-ip source-address: S
the c
no
group. This option takes effect on IGMPv3 snooping devices.
vlan vlan-id: Specifies a VLAN
all: Specifies all VLANs.
# Configure Ten-Gig
(1.1.1.1, 2 2 5 . 0 . 0 .1) i n V L A N 2.
<Sysname> system-view
[Sysname] igmp-snoopin
[Sysname-igmp-snooping] quit
36