HP 5900 series Command Reference

Usage guidelines
ords match the source address and multicast
icast data packets, respectively.
d in an ACL rule, the rule does not take effect. The other optional
d in the ACL rules are ignored.
uration takes effect.
Examples
6 multicast source policy to permit IPv6 multicast data from the
data from the source 3121: :2 .
[Sysname-acl6-basic-2000] rule permit source 3121::1 128
128
[Sysname] ipv6 pim
[Sysname-pim6] source-policy 2000
Use undo spt-switch-threshold to restore the default.
Syntax
{ immediacy | infinity } [ group-policy acl6-number ]
hreshold [ immediacy | infinity ] [ group-policy acl6-number ]
r receiving the first IPv6 multicast packet.
Views
Predefine
Parameters
tely.
isables the switchover to SPT.
acl6-number: Specifies an IPv6 basic ACL number in the range of 2000 to 2999. If you
The specified ACL does not exist.
In an IPv6 basic ACL, the source keyword matches the source address in IPv6 multicast data packets. In
an IPv6 advanced ACL, the source and destination keyw
group address in IPv6 mult
If you specify the vpn-instance keywor
parameters except the time-range keyword and the fragment keywor
If you execute this command multiple times, the most recent config
# On the public network, configure an IPv
source 3121: :1 and deny
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule deny source 3121::2
[Sysname-acl6-basic-2000] quit
[Sysname-pim6] quit
spt-switch-threshold (IPv6 PIM view)
Use spt-switch-threshold to configure the switchover to SPT.
spt-switch-threshold
undo spt-switch-t
Default
The switch immediately triggers the switchover to SPT afte
IPv6 PIM view
d user roles
network-admin
immediacy: Triggers the switchover to SPT immedia
infinity: D
group-policy
specify an ACL, the configuration applies to the IPv6 multicast groups that the ACL permits. The
configuration applies to all IPv6 multicast groups when one of the following conditions exists:
• You do not specify an ACL.
•
• The specified ACL does not have valid rules.
340

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)