Examples
# Display dynamic router port information for VLAN 2.
<Sysname> display igmp-snooping router-port vlan 2
VLAN 2:
Router slots (0 in total):
Router ports (2 in total):
XGE1/0/1 (00:01:30)
XGE1/0/2 (00:00:23)
Table 3 Command output
Field Descri
tion
VLAN 2 VLAN ID.
Router slots (0 in total)
Member IDs of the member devices that have router ports and the total number of
the member devices (excluding the specified member device).
Router ports (2 in total) Dynamic router ports, and the total number of the dynamic router ports.
(00:01:30)
Remaining aging time for the dynamic router port.
• For a global port, this field is always displayed.
• For a non-global port, this field is displayed if the port is on the master device.
Otherwise, you must specify the slot slot-number option to display this field.
Related commands
reset igmp-snooping router-port
display igmp-snooping static-group
Use display igmp-snooping static-group to display static IGMP snooping forwarding entries.
Syntax
display igmp-snooping static-group [ group-address | source-address ] * [ vlan vlan-id ] [ verbose ] [ slot
slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group-address: Specifies a multicast group by its IP address in the range of 224.0.1.0 to
239.255.255.255. If you do not specify a multicast group, the command displays static IGMP snooping
forwarding entries for all multicast groups.
source-address: Specifies a multicast source by its IP address. If you do not specify a multicast source, the
command displays static IGMP snooping forwarding entries for all multicast sources.
vlan vlan-id: Specifies a VLAN by its VLAN ID in the range of 1 to 4094. If you do not specify a VLAN,
the command displays static IGMP snooping forwarding entries for all VLANs.
5
To Next Page
Loading...
Need help?
General
