HP 5900 series Command Reference

Use undo encap-data-enable to restore the default.
Syntax
encap-data-enable
undo encap-data-enable
Default
An SA message contains only (S, G) entries. No multicast data is encapsulated in an SA message.
Views
MSDP view
Predefined user roles
network-admin
Examples
# Enable multicast data encapsulation in SA messages on the public network.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] encap-data-enable
import-source
Use import-source to configure an SA message creation policy.
Use undo import-source to remove the configured SA message creation policy.
Syntax
import-source [ acl acl-number ]
undo import-source
Default
When an SA message is created, all the (S, G) entries within the domain are advertised in the SA
message.
Views
MSDP view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an IPv4 basic or advanced ACL number in the range of 2000 to 3999. If you
specify an ACL, the command advertises only the (S, G) entries that the ACL permits. The command does
not advertise any (S, G) entries when any of the following conditions exists:
• You do not specify an ACL.
• The specified ACL does not exist.
• The specified ACL does not have valid rules.
Usage guidelines
During ACL matching, the protocol ID in the ACL rule is not verified.
171

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)