153
• timer join-prune (PIM view)
pim triggered-hello-delay
Use pim triggered-hello-delay to set the triggered hello delay.
Use undo pim triggered-hello-delay to restore the default.
Syntax
pim triggered-hello-delay delay
undo pim triggered-hello-delay
Default
The triggered hello delay is 5 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
delay: Sets a triggered hello delay in the range of 1 to 60 seconds.
Usage guidelines
The triggered hello delay defines the maximum delay for sending a hello message.
Examples
# Set the triggered hello delay to 3 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim triggered-hello-delay 3
register-policy (PIM view)
Use register-policy to configure a PIM register policy.
Use undo register-policy to remove the configured PIM register policy.
Syntax
register-policy acl-number
undo register-policy
Default
PIM register policies are not configured.
Views
PIM view
Predefined user roles
network-admin
To Next Page
Loading...
