HP 5900 series Command Reference

[Sysname-igmp-snooping] overflow-replace vlan 2
Related c
report-aggregation (IGMP-snooping view)
Use undo report-aggregation to disable IGMP report suppression.
Syntax
undo report-aggregation
Default
IGMP report suppression is enabled.
Views
iew
Predefine
twork-admin
Examples
pression.
t-aggregation
reset igmp-snooping group
igmp-snooping group to remove the dynamic IGMP snooping forwarding entries for multicast
groups.
Syntax
reset igmp-snooping group { group-address [ source-address ] | all } [ vlan vlan-id ]
Views
Predefine
ork-admin
Paramete
ifies a multicast group by its IP address in the range of 224.0.1.0 to
urce, the
MP snooping forwarding entries for all multicast sources.
ommands
igmp-snooping overflow-replace
Use report-aggregation to enable IGMP report suppression.
report-aggregation
IGMP-snooping v
d user roles
ne
# Disable IGMP report sup
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] undo repor
Use reset
User view
d user roles
netw
rs
group-address: Spec
239.255.255.255.
source-address: Specifies a multicast source by its IP address. If you do not specify a multicast so
command removes the dynamic IG
all: Specifies all multicast groups.
41

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)