HP 5900 series - Display Mld-Snooping Group

Report source IP: FE80::2FF:FFFF:FE00:2
Done source IP: FE80::2FF:FFFF:FE00:3
Dot1p-priority: --
Table 59 Command output
Field Descri
p
tion
MLD snooping
MLD snooping status:
• Enabled.
• Disabled.
Drop-unknown
Status of dropping unknown IPv6 multicast data:
• Enabled.
• Disabled.
Version MLD snooping version.
Host-aging-time Aging timer for the dynamic member port.
Router-aging-time Aging timer for the dynamic router port.
Max-response-time Maximum time for responding to MLD general queries.
Last-listener-query-interval Interval for sending MLD multicast-address-specific queries.
Report-aggregation
Status of MLD report suppression:
• Enabled.
• Disabled.
Dot1p-priority
802.1p priority for MLD messages, where two hyphens (--) mean that
it is not configured.
Querier Whether the MLD snooping querier is enabled.
Query-interval Interval for sending MLD general queries.
General-query source IP Source IPv6 address of MLD general queries.
Special-query source IP Source IPv6 address of MLD multicast-address-specific queries.
Report source IP Source IPv6 address of MLD reports.
Done source IP Source IPv6 address of MLD done messages.
display mld-snooping group
Use display mld-snooping group to display dynamic MLD snooping forwarding entries.
Syntax
display mld-snooping group [ ipv6-group-address | ipv6-source-address ] * [ vlan vlan-id ] [ verbose ]
[ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
199