HP 5900 series Command Reference

Default
The MLD last listener query interval in a VLAN is 1 second.
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval: Sets an MLD last listener query interval in the range of 1 to 25 seconds.
Usage guidelines
The MLD last listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response time for MLD multicast-address-specific queries in a VLAN.
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
This command and the last-listener-query-interval command in MLD-snooping view have the same
function but different effective ranges:
• The last-listener-query-interval command in MLD-snooping view takes effect on all VLANs.
• The mld-snooping last-listener-query-interval command takes effect on the current VLAN.
For a VLAN, the mld-snooping last-listener-query-interval command takes priority over the
last-listener-query-interval command in MLD-snooping view.
Examples
# In VLAN 2, enable MLD snooping, and set the MLD last listener query interval to 3 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping last-listener-query-interval 3
Related commands
• enable (MLD-snooping view)
• last-listener-query-interval (MLD-snooping view)
• mld-snooping enable
mld-snooping max-response-time
Use mld-snooping max-response-time to set the maximum response time for MLD general queries in a
VLAN.
Use undo mld-snooping max-response-time to restore the default.
Syntax
mld-snooping max-response-time interval
undo mld-snooping max-response-time
222

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)