147
[Sysname-Vlan-interface100] pim hello-option override-interval 2000
Related commands
• hello-option lan-delay (PIM view)
• hello-option override-interval (PIM view)
• pim hello-option lan-delay
pim holdtime join-prune
Use pim holdtime join-prune to set the joined/pruned state holdtime timer on an interface.
Use undo pim holdtime join-prune to restore the default.
Syntax
pim holdtime join-prune time
undo pim holdtime join-prune
Default
The joined/pruned state holdtime timer is 210 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
time: Sets a joined/pruned state holdtime timer in the range of 1 to 65535 seconds.
Usage guidelines
You can set the joined/pruned state holdtime timer for all interfaces in PIM view or for the current
interface in interface view. The configuration made in interface view takes priority over the configuration
made in PIM view.
To prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
messages to be less than the joined/pruned state holdtime timer.
Examples
# Set the joined/pruned state holdtime timer to 280 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim holdtime join-prune 280
Related commands
• holdtime join-prune (PIM view)
• pim timer join-prune
pim neighbor-policy
Use pim neighbor-policy to configure a PIM hello policy to define the legal source address range for
hello messages.
To Next Page
Loading...
Need help?
General
