HP 5900 series Command Reference

Views
VLAN view
Predefine
twork-admin
Usage gu
oping for a VLAN before you execute this command.
-VLAN only after you remove the sub-VLAN from the multicast VLAN.
Examples
nable the IGMP snooping querier.
igmp-snooping
nable
uerier
-snooping query-interval
set the IGMP general query interval for a VLAN.
Use undo igmp-snooping query-interval to restore the default.
Syntax
igmp-snooping query-interval interval
nooping query-interval
al query interval in a VLAN is 125 seconds.
les
Paramete
2 to 31744 seconds.
elines
lticast group members, set the IGMP general query interval to be greater
r IGMP general queries.
d user roles
ne
idelines
You must enable IGMP sno
This command takes effect on a sub
# In VLAN 2, enable IGMP snooping, and e
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping e
[Sysname-vlan2] igmp-snooping q
Related commands
• enable (IGMP-snooping view)
• igmp-snooping enable
• subvlan (multicast VLAN view)
igmp
Use igmp-snooping query-interval to
undo igmp-s
Default
The IGMP gener
Views
VLAN view
Predefined user ro
network-admin
rs
interval: Sets an IGMP general query interval in the range of
Usage guid
You must enable IGMP snooping for a VLAN before you execute this command.
To avoid mistakenly deleting mu
than the maximum response time fo
31

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)