HP 5900 series Command Reference

346
timer
Use timer join-prune to set the global join/prune interval.
to restore the default.
Syntax
timer join-prune interval
/prune interval is 60 seconds.
ser roles
Usage gu
PIM view or for the current interface in
e configuration takes effect after the current interval ends.
erval for sending join/prune
Examples
seconds on the public network.
system-view
Related c
• holdtime join-prune (IPv6 PIM view)
• ipv6 pim timer join-prune
Related commands
ipv6 pim timer hello
join-prune (IPv6 PIM view)
Use undo timer join-prune
undo timer join-prune
Default
The global join
Views
IPv6 PIM view
Predefined u
network-admin
Parameters
interval: Sets a join/prune interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds,
the interface does not send join or prune messages.
idelines
You can set the join/prune interval for all interfaces in IPv6
interface view. The configuration made in interface view takes priority over the configuration made in
IPv6 PIM view.
Th
To prevent the upstream neighbors from aging out, you must configure the int
messages to be less than the joined/pruned state holdtime timer.
# Set the global join/prune interval to 80
<Sysname>
[Sysname] ipv6 pim
[Sysname-pim6] timer join-prune 80
ommands

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)