161
Examples
# On the public network, configure the interface with the IP address of 11.110.0.6 as a static RP for
multicast group range 225.1.1.0/24, and give priority to this static RP.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 225.1.1.0 0.0.0.255
[Sysname-acl-basic-2001] quit
[Sysname] pim
[Sysname-pim] static-rp 11.110.0.6 2001 preferred
Related commands
display pim rp-info
timer hello (PIM view)
Use timer hello to set the global hello interval.
Use undo timer hello to restore the default.
Syntax
timer hello interval
undo timer hello
Default
The global hello interval is 30 seconds.
Views
PIM view
Predefined user roles
network-admin
Parameters
interval: Sets a hello interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds, the
switch does not send hello messages.
Usage guidelines
You can set the hello interval for all interfaces in PIM view or for the current interface in interface view.
The configuration made in interface view takes priority over the configuration made in PIM view.
Examples
# Set the global hello interval to 40 seconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer hello 40
Related commands
pim timer hello
To Next Page
Loading...
Need help?
General
