Usage gu
is an RP, disabling the switchover to SPT mi
idelines
CAUTION:
If the device
ht cause multicast traffic forwardin
failures on
derstand its impact on yourthe source-side DR. When disabling the switchover to SPT, be sure you fully un
network.
In an IPv6 basic ACL, the source keyword matches the multicast group address in IPv6 multicast packets.
in an ACL rule, the rule does not take effect. The other optional
ord and the fragment keyword in the ACL rules are ignored.
Examples
blic network.
[Sysname] ipv6 pim
itch-threshold infinity
ssm-policy (IPv6 PIM view)
Use undo ssm-policy to restore the default.
Syntax
-number
Predefine
Paramete
r in the range of 2000 to 2999.
elines
up address in MLD reports.
nce keyword in an ACL rule, the rule does not take effect. The other optional
ord and the fragment keyword in the ACL rules are ignored.
nge. If a packet to an IPv6
used ACL, the multicast mode for the packet is IPv6 PIM-SSM.
t mode is IPv6 PIM-SM.
Examples
# Configure the IPv6 SSM group range to be FF3E:0:8192::/96.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
If you specify the vpn-instance keyword
parameters except the time-range keyw
# Disable the switchover to SPT on receiver-side DR on the pu
<Sysname> system-view
[Sysname-pim6] spt-sw
Use ssm-policy to configure the IPv6 SSM group range.
ssm-policy acl6
undo ssm-policy
Default
The IPv6 SSM group range is FF3x::/32, where x can be any valid scope.
Views
IPv6 PIM view
d user roles
network-admin
rs
acl6-number: Specifies an IPv6 basic ACL numbe
Usage guid
In an IPv6 basic ACL, the source keyword matches the multicast gro
If you specify the vpn-insta
parameters except the time-range keyw
You can use this command to define an IPv6 multicast group address ra
multicast group is permitted by the
Otherwise, the multicas
341
To Next Page
Loading...
Need help?
General
