HP 5900 series Command Reference

This command and the mld-snooping max-response-time command have the same function but different
effective ranges:
• The max-response-time command in MLD-snooping view takes effect on all VLANs.
• The mld-snooping max-response-time command takes effect on the current VLAN.
For a VLAN, the mld-snooping max-response-time command takes priority over the max-response-time
command in MLD-snooping view.
Examples
# Set the global maximum response time for MLD general queries to 5 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] max-response-time 5
Related commands
mld-snooping max-response-time
mld-snooping
Use mld-snooping to enable MLD snooping globally and enter MLD-snooping view.
Use undo mld-snooping to disable MLD snooping globally.
Syntax
mld-snooping
undo mld-snooping
Default
MLD snooping is globally disabled.
Views
System view
Predefined user roles
network-admin
Examples
# Enable MLD snooping globally and enter MLD -snooping view.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping]
Related commands
• enable (MLD-snooping view)
• mld-snooping enable
mld-snooping done source-ip
Use mld-snooping done source-ip to configure a source IPv6 address for MLD done messages.
Use undo mld-snooping done source-ip to restore the default.
212

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)