Predefined user roles
Paramete
ets a join/prune interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds,
Usage gu
IM view or for the current interface in
s priority over the configuration made in
prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
Examples
v6 pim timer join-prune 80
Related c
ipv6 pim triggered-hello-delay
Use ipv6 pim triggered-hello-delay to set the triggered hello delay.
ay to restore the default.
Syntax
ipv6 pim triggered-hello-delay delay
ello delay is 5 seconds.
ser roles
elines
llo message.
network-admin
rs
interval: S
the interface does not send join or prune messages.
idelines
You can set the join/prune interval for all interfaces in IPv6 P
interface view. The configuration made in interface view take
IPv6 PIM view.
The configuration takes effect after the current interval ends.
To
messages to be less than the joined/pruned state holdtime timer.
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
system-view <Sysname>
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip
ommands
• ipv6 pim holdtime join-prune
• timer join-prune (IPv6 PIM view)
Use undo ipv6 pim triggered-hello-del
undo ipv6 pim triggered-hello-delay
Default
The triggered h
Views
Interface view
Predefined u
network-admin
Parameters
delay: Sets a triggered hello delay in the range of 1 to 60 seconds.
Usage guid
The triggered hello delay defines the maximum delay for sending a he
336
To Next Page
Loading...
