HP 5900 series Command Reference

Table 31 Command output
Field Descri
p
tion
RPF neighbor IP address of the RPF neighbor.
Referenced route/mask Referenced route and its mask length.
Referenced route type
Type of the referenced route:
• igp—IGP unicast route.
• egp—EGP unicast route.
• unicast (direct)—Directly connected unicast route.
• unicast—Other unicast routes, such as static unicast route.
• multicast static—Static multicast route.
Route selection rule
Rule for RPF route selection:
• Route preference.
• Longest prefix match.
Load splitting rule Status of the load splitting rule: enabled or disabled.
Related commands
• display multicast forwarding-table
• display multicast routing-table
ip rpf-route-static
Use ip rpf-route-static to configure a static multicast route.
Use undo ip rpf-route-static to delete a static multicast route.
Syntax
ip rpf-route-static [ vpn-instance vpn-instance-name ] source-address { mask-length | mask }
{ rpf-nbr-address | interface-type interface-number } [ preference preference ]
undo ip rpf-route-static [ vpn-instance vpn-instance-name ] source-address { mask-length | mask }
{ rpf-nbr-address | interface-type interface-number }
Default
No static multicast route exists.
Views
System view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command configures a static multicast
route on the public network.
source-address: Specifies a multicast source address.
mask-length: Specifies an address mask length in the range of 0 to 32.
77

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)