Usage guide
by the following formula:
GMP general query interval ] + [ maximum response time for IGMP general queries ]
the value calculated by the
l ] × 2 + [ maximum response time for IGMP general queries ]
e command have the same function but different
ges:
GMP-snooping view takes effect on all VLANs.
oping host-aging-time command takes effect on the current VLAN.
igmp-snooping host-aging-time command takes priority over the host-aging-time
Examples
obally.
<Sysname> system-view
-snooping
ing] host-aging-time 300
ommands
-snooping
ping to enable IGMP snooping globally and enter IGMP-snooping view.
snooping to disable IGMP snooping globally.
Default
ing is globally disabled.
Views
Predefined user roles
Examples
iew.
[Sysname] igmp-snooping
lines
To avoid mistakenly deleting multicast group members, set the aging timer for dynamic member ports to
be greater than the value calculated
[ I
HP recommends that you set the aging timer of dynamic member ports to
following formula:
[ IGMP general query interva
This command and the igmp-snooping host-aging-tim
effective ran
• The host-aging-time command in I
• The igmp-sno
For a VLAN, the
command in IGMP-snooping view.
# Set the aging timer for dynamic member ports to 300 seconds gl
[Sysname] igmp
[Sysname-igmp-snoop
Related c
igmp-snooping host-aging-time
igmp
Use igmp-snoo
Use undo igmp-
Syntax
igmp-snooping
undo igmp-snooping
IGMP snoop
System view
network-admin
# Enable IGMP snooping globally and enter IGMP-snooping v
<Sysname> system-view
[Sysname-igmp-snooping]
18
To Next Page
Loading...
