HP 5900 series Command Reference

[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname] interface ten-gigabitethernet 1/0/1
0.1 source-ip
-snooping static-router-port
static router port.
Use undo igmp-snooping static-router-port to remove a static router port.
Syntax
igmp-snooping static-router-port vlan vlan-id
tatic router port.
view, Layer 2 aggregate interface view
Predefine
twork-admin
Paramete
nge of 1 to 4094.
Examples
1/0/1 as a static router port in VLAN 2.
-snooping version
specify an IGMP snooping version.
Use undo igmp-snooping version to restore the default.
Syntax
igmp-snooping version version-number
nooping version
ing version in a VLAN is 2.
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname-Ten-GigabitEthernet1/0/1] igmp-snooping static-group 225.0.
1.1.1.1 vlan 2
igmp
Use igmp-snooping static-router-port to configure a port as a
undo igmp-snooping static-router-port { all | vlan vlan-id }
Default
A port is not a s
Views
Layer 2 Ethernet interface
d user roles
ne
rs
all: Specifies all VLANs.
vlan vlan-id: Specifies a VLAN by its VLAN ID in the ra
# Configure Ten-GigabitEthernet
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] igmp-snooping static-router-port vlan 2
igmp
Use igmp-snooping version to
undo igmp-s
Default
The IGMP snoop
37

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)