Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command displays the DF information of
IPv6 BIDIR-PIM on the public network.
ipv6-rp-address: Specifies an RP of IPv6 BIDIR-PIM by its IPv6 address.
Examples
# Display the DF information of IPv6 BIDIR-PIM on the public network.
<Sysname> display ipv6 pim df-info
RP address: 1:1::1
Interface State DF-Pref DF-Metric DF-Uptime DF-Address
Vlan1 Lose 0 0 00:20:13 FE80:7:11::1
Vlan2 Win 10 1 00:20:12 FE80:10:1::2 (local)
Table 90 Command output
Field Descri
tion
State
DF election state:
• Win—The interface wins the DF election.
• Lose—The interface loses the DF election.
• Offer—The interface is in the initial state of the DF election.
• Backoff—The interface is acting as the DF, but there are
more appropriate devices running for the DF.
• -—The interface does not participate in the DF election.
DF-Pref Advertised route preference for DF election.
DF-Metric Advertised route metric for DF election.
DF-Uptime Length of time the DF has been up.
DF-Address
IP address of DF. If the DF resides on the device where the
command is executed, this field displays (local) after the
address.
display ipv6 pim interface
Use display ipv6 pim interface to display IPv6 PIM information on an interface.
Syntax
display ipv6 pim [ vpn-instance vpn-instance-name ] interface [ interface-type interface-number ]
[ verbose ]
Views
Any view
309
To Next Page
Loading...
Need help?
General
