HP 5900 series Command Reference

[Sysname-vlan2] pim-snooping enable
[Sysname-vlan2] pim-snooping graceful-restart join-aging-time 600
Related c
pim-snooping enable
aging time for PIM snooping global
Use undo pim-snooping graceful-restart neighbor-aging-time to restore the default.
Syntax
undo pim-snooping graceful-restart neighbor-aging-time
Default
The default setting is 105 seconds.
Views
Predefine
ork-admin
Paramete
ets an aging time in the range of 105 to 18000 seconds.
Usage gu
u must enable PIM snooping for a VLAN before you execute this command for the VLAN.
Examples
M snooping global neighbor ports to 300 seconds on the new
r election.
ping] quit
lan2] pim-snooping graceful-restart neighbor-aging-time 300
Related c
pim-snooping enable
Use reset pim-snooping statistics to clear statistics for the PIM messages learned through PIM snooping.
ommands
pim-snooping graceful-restart neighbor-aging-time
Use pim-snooping graceful-restart neighbor-aging-time to set the
neighbor ports on the new master device in IRF master election.
pim-snooping graceful-restart neighbor-aging-time interval
VLAN view
d user roles
netw
rs
interval: S
idelines
A global neighbor port is a Layer 2 aggregate interface that acts as a neighbor port.
Yo
# In VLAN 2, set the aging time for PI
master device in IRF maste
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snoo
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] pim-snooping enable
[Sysname-v
ommands
reset pim-snooping statistics
52

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)