HP 5900 series - State-Refresh-Hoplimit (Ipv6 PIM View); State-Refresh-Interval (Ipv6 PIM View)

[Sysname-acl6-basic-2000] rule permit source ff3e
[Sysname-acl6-basic-2000] quit
:0:8192:: 96
refresh-hoplimit (IPv6 PIM view)
Use state-refresh-hoplimit to set the hop limit for state refresh messages.
Use undo state-refresh-hoplimit to restore the default.
state-refresh-hoplimit hoplimit-value
esh-hoplimit
r state refresh messages is 255.
user roles
Paramete
op limit for state refresh messages, in the range of 1 to 255.
Examples
p limit for state refresh messages to 45 on the public network.
45
Related commands
• state-refresh-interval (IPv6 PIM view)
refresh-interval (IPv6 PIM view)
Use state-refresh-interval to set the state refresh interval.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
esh-interval
terval is 60 seconds.
[Sysname] ipv6 pim
[Sysname-pim6] ssm-policy 2000
state-
Syntax
undo state-refr
Default
The hop limit fo
Views
IPv6 PIM view
Predefined
network-admin
rs
hoplimit-value: Sets a h
# Set the ho
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-hoplimit
• ipv6 pim state-refresh-capable
• state-refresh-rate-limit (IPv6 PIM view)
state-
undo state-refr
Default
The state refresh in
342