HP 5900 series Command Reference

139
Parameters
interval: Sets an override interval in the range of 1 to 65535 milliseconds.
Usage guidelines
You can set the override interval for all interfaces in PIM view or for the current interface in interface view.
The configuration made in interface view takes priority over the configuration made in PIM view.
Examples
# Set the global override interval to 2000 milliseconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] hello-option override-interval 2000
Related commands
• hello-option lan-delay (PIM view)
• pim hello-option lan-delay
• pim hello-option override-interval
holdtime join-prune (PIM view)
Use holdtime join-prune to set the global joined/pruned state holdtime timer.
Use undo holdtime join-prune to restore the default.
Syntax
holdtime join-prune time
undo holdtime join-prune
Default
The global joined/pruned state holdtime timer is 210 seconds.
Views
PIM view
Predefined user roles
network-admin
Parameters
time: Sets a joined/pruned state holdtime timer in the range of 1 to 65535 seconds.
Usage guidelines
You can set the joined/pruned state holdtime timer for all interfaces in PIM view or for the current
interface in interface view. The configuration made in interface view takes priority over the configuration
made in PIM view.
To prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
messages to be less than the joined/pruned state holdtime timer.
Examples
# Set the global joined/pruned state holdtime timer to 280 seconds on the public network.
<Sysname> system-view
[Sysname] pim

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)