HP 5900 series Command Reference

150
Default
PIM-SM is disabled.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only when IP multicast routing is enabled. If the interface belongs to a VPN
instance, make sure IP multicast routing is enabled on the VPN instance.
Examples
# On the public network, enable IP multicast routing, and enable PIM-SM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] quit
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim sm
Related commands
multicast routing
pim state-refresh-capable
Use pim state-refresh-capable to enable the state refresh feature on an interface.
Use undo pim state-refresh-capable to disable the state refresh feature.
Syntax
pim state-refresh-capable
undo pim state-refresh-capable
Default
The state refresh feature is enabled.
Views
Interface view
Predefined user roles
network-admin
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim state-refresh-capable
Related commands
• state-refresh-interval (PIM view)
• state-refresh-rate-limit (PIM view)

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)