igmp static-group
Use igmp static-group to configure an interface as a static group member of a multicast group.
Use undo igmp static-group to restore the default.
Syntax
igmp static-group group-address [ source source-address ]
undo igmp static-group { all | group-address [ source source-address ] }
Default
An interface is not a static group member of multicast groups.
Views
Interface view
Predefined user roles
network-admin
Parameters
group-address: Specifies a multicast group by its IP address in the range of 224.0.1.0 to
239.255.255.255.
source-address: Specifies a multicast source by its IP address. If you do not specify a multicast source, the
command configures an interface as a static group member of the multicast groups with all multicast
source addresses.
all: Specifies all multicast groups that the interface has statically joined.
Usage guidelines
If the specified multicast address is in the SSM multicast address range, you must specify a multicast
source address at the same time. Otherwise, IGMP routing entries cannot be established. No such a
restriction exists if the specified multicast group address is not in the SSM multicast address range.
Examples
# Configure VLAN-interface 100 as a static group member of the multicast group 224.1.1.1.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp static-group 224.1.1.1
# Configure VLAN-interface 100 as a static group member of the multicast source and group (192.168.1.1,
232.1.1.1).
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp static-group 232.1.1.1 source 192.168.1.1
igmp version
Use igmp version to specify an IGMP version for an interface.
Use undo igmp version to restore the default.
102
To Next Page
Loading...
Need help?
General
