HP 5900 series Command Reference

112
PIM commands
The term "interface" in this chapter collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.
You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see
Layer 2—LAN Switching Configuration Guide).
auto-rp enable
Use auto-rp enable to enable Auto-RP listening.
Use undo auto-rp enable to disable Auto-RP listening.
Syntax
auto-rp enable
undo auto-rp enable
Default
Auto-RP listening is disabled.
Views
PIM view
Predefined user roles
network-admin
Examples
# Enable Auto-RP listening on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] auto-rp enable
bidir-pim enable (PIM view)
Use bidir-pim enable to enable BIDIR-PIM.
Use undo bidir-pim enable to disable BIDIR-PIM.
Syntax
bidir-pim enable
undo bidir-pim enable
Default
BIDIR-PIM is disabled.
Views
PIM view

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)