To Next Page

To Previous Page

1.1.0.0/16 10 7.12.0.1 Vlan12

7.11.0.1 Vlan11

2.2.2.0/24 20 7.11.0.1 Vlan11

3.3.3.3/32 50 7.12.0.1 Vlan12

Table 30 Command output

Field Descri

tion

Destinations Number of the multicast destination addresses.

Routes Number of routes.

Destination/Mask Destination address and mask length.

Pre Route preference.

RPF neighbor IP address of the RPF neighbor to the reachable destination.

Interface Outgoing interface to the reachable destination.

display multicast rpf-info

Use display multicast rpf-info to display RPF information for multicast sources.

Syntax

display multicast [ vpn-instance vpn-instance-name ] rpf-info source-address [ group-address ]

Views

Any view

Predefined user roles

network-admin

network-operator

Parameters

vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string

of 1 to 31 characters. If you do not specify a VPN instance, the command displays RPF information for

multicast sources on the public network.

source-address: Specifies a multicast source address.

group-address: Specifies a multicast group address in the range of 224.0.1.0 to 239.255.255.255.

Examples

# Display the RPF information of multicast source 192.168.1.55 on the public network.

<Sysname> display multicast rpf-info 192.168.1.55

RPF information about source 192.168.1.55:

RPF interface: Vlan-interface1, RPF neighbor: 10.1.1.1

Referenced route/mask: 192.168.1.0/24

Referenced route type: igp

Route selection rule: preference-preferred

Load splitting rule: disable

Other manuals for HP 5900 series

Questions and Answers:

Need help?

Do you have a question about the HP 5900 series and is the answer not in the manual?

General