• IGMPv3 IS_EX and IGMPv3 TO_EX reports that do not carry multicast source addresses.
time-range keyword and the fragment keyword in the ACL rules are ignored.
u can configure different ACL rules on a port in different VLANs. However, for a given VLAN, a newly
only on the multicast groups that a port joins dynamically.
mp-snooping group-policy command have the same function but different
t on all ports.
command takes effect on the current port.
priority over the group-policy command in
ing view.
Examples
# Globally configure a multicast group policy for VLAN 2 so that the hosts in this VLAN can join only the
<Sysname> system-view
ce 225.1.1.1 0
[Sysname] igmp-snooping
g] group-policy 2000 vlan 2
Related c
igmp-snooping group-policy
host-aging-time (IGMP-snooping view)
set the aging timer for dynamic member ports globally.
-aging-time to restore the default.
Syntax
t-aging-time interval
Views
Predefine
Parameters
ging timer for dynamic member ports, in the range of 1 to 8097894 seconds.
If you specify the vpn-instance keyword in an ACL rule, the rule does not take effect. The other optional
parameters except the
Yo
configured ACL rule overrides the existing one.
This command takes effect
This command and the ig
effective ranges:
• The group-policy command in IGMP-snooping view takes effec
• The igmp-snooping group-policy
For a port, the igmp-snooping group-policy command takes
IGMP-snoop
m u l t i c a s t g r o u p 2 25 .1.1.1.
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit sour
[Sysname-acl-basic-2000] quit
[Sysname-igmp-snoopin
ommands
Use host-aging-time to
Use undo host
hos
undo host-aging-time
Default
The default setting is 260 seconds.
IGMP-snooping view
d user roles
network-admin
interval: Sets an a
17
To Next Page
Loading...
Need help?
General
