HP 5900 series Command Reference

<Sysname> system-view
ption override-interval 2000
Related c
• hello-option lan-delay (IPv6 PIM view)
view)
• ipv6 pim hello-option lan-delay
ipv6 p
Use ipv6 pim holdtime join-prune to set the joined/pruned state holdtime timer on an interface.
une to restore the default.
Syntax
ipv6 pim holdtime join-prune time
ned state holdtime timer is 210 seconds.
Usage gu
ade in interface view takes priority over the configuration
ade in IPv6 PIM view.
terval to be less
te holdtime timer.
Examples
terface 100.
system-view
00
ipv6 pim holdtime join-prune 280
Related commands
ew)
• ipv6 pim timer join-prune
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim hello-o
ommands
• hello-option override-interval (IPv6 PIM
im holdtime join-prune
Use undo ipv6 pim holdtime join-pr
undo ipv6 pim holdtime join-prune
Default
The joined/pr
Views
u
Inte
Predefined user roles
rface view
network-admin
Parameters
time: Sets a joined/pruned state holdtime timer in the range of 1 to 65535 seconds.
idelines
You can set the joined/pruned state holdtime timer for all interfaces in IPv6 PIM view or for the current
interface in interface view. The configuration m
m
To prevent the upstream neighbors from aging out, you must configure the join/prune in
than the joined/pruned sta
# Set the joined/pruned state holdtime timer to 280 seconds on VLAN-in
<Sysname>
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface100]
• holdtime join-prune (IPv6 PIM vi
331

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)