static-rpf-peer
Use static-rpf-peer to configure a static RPF peer.
Use undo static-rpf-peer to remove a static RPF peer.
Syntax
static-rpf-peer peer-address [ rp-policy ip-prefix-name ]
undo static-rpf-peer peer-address
Default
No static RPF peer is configured.
Views
MSDP view
Predefined user roles
network-admin
Parameters
peer-address: Specifies an MSDP peer by its IP address.
rp-policy ip-prefix-name: Specifies a filtering policy based on the RP addresses in SA messages. The
ip-prefix-name argument is the filtering policy name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
When you configure multiple static RPF peers at the same time, observe the following rules:
• If the rp-policy keyword is specified for all the static RPF peers, SA messages from the active static
RPF peers are filtered according to the configured filtering policy. The router receives only SA
messages that have passed the filtering.
• If the rp-policy keyword is not specified for the static RPF peers, the router receives all SA messages
from the active static RPF peers.
Examples
# Configure a static RPF peer on the public network.
<Sysname> system-view
[Sysname] ip prefix-list list1 permit 130.10.0.0 16 greater-equal 16 less-equal 32
[Sysname] msdp
[Sysname-msdp] peer 130.10.7.6 connect-interface vlan-interface 100
[Sysname-msdp] static-rpf-peer 130.10.7.6 rp-policy list1
Related commands
• display msdp peer-status
• ip prefix-list
timer retry
Use timer retry to configure the interval between MSDP peering connection attempts.
Use undo timer retry to restore the default.
183
To Next Page
Loading...
Need help?
General
