HP 5900 series - Igmp-Snooping Special-Query Source-Ip

Predefined user roles
Usage gu
nction but
ort.
r a port, the igmp-snooping source-deny command and the source-deny command in IGMP-snooping
Examples
0/1.
interface ten-gigabitethernet 1/0/1
/1] igmp-snooping source-deny
igmp-
dress for IGMP group-specific
queries.
restore the default.
Syntax
igmp-snooping special-query source-ip ip-address
Default
source IP address of IGMP
group-specific queries is the source IP address of IGMP general queries. Otherwise, the source IP address
of IGMP group-specific queries is the IP address of the current VLAN interface. If the current VLAN
s not have an IP address, the source IP address is 0.0.0.0.
ser roles
elines
network-admin
idelines
This command and the source-deny command in IGMP-snooping view have the same fu
different effective ranges:
• The source-deny command in IGMP-snooping view takes effect on the specified ports.
• The igmp-snooping source-deny command takes effect on the current p
Fo
view have the same priority, and the most recent configuration takes effect.
# Enable source port filtering for multicast data on Ten-GigabitEthernet 1/
system-view <Sysname>
[Sysname]
[Sysname-Ten-GigabitEthernet1/0
Related commands
source-deny (IGMP-snooping view)
snooping special-query source-ip
Use igmp-snooping special-query source-ip to configure a source IP ad
Use undo igmp-snooping special-query source-ip to
undo igmp-snooping special-query source-ip
If the IGMP snooping querier has received IGMP general queries, the
interface doe
Views
VLAN view
Predefined u
network-admin
Parameters
ip-address: Specifies a source IP address for IGMP group-specific queries.
Usage guid
You must enable IGMP snooping for a VLAN before you execute this command.
35