EasyManuals Logo

HP 5900 series Command Reference

HP 5900 series
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
159
Predefined user roles
network-admin
Parameters
time: Sets an amount of time that the switch waits before receiving a new refresh message, in the range
of 1 to 65535 seconds.
Examples
# Configure the switch to wait 45 seconds before it receives a new state refresh message on the public
network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-rate-limit 45
Related commands
pim state-refresh-capable
state-refresh-interval (PIM view)
state-refresh-ttl (PIM view)
state-refresh-ttl (PIM view)
Use state-refresh-ttl to set the TTL value for state refresh messages.
Use undo state-refresh-ttl to restore the default.
Syntax
state-refresh-ttl ttl-value
undo state-refresh-ttl
Default
The TTL value of state refresh messages is 255.
Views
PIM view
Predefined user roles
network-admin
Parameters
ttl-value: Sets a TTL value for state refresh messages, in the range of 1 to 255.
Examples
# Set the TTL value for state refresh messages to be 45 on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-ttl 45
Related commands
pim state-refresh-capable (PIM view)
state-refresh-interval (PIM view)
state-refresh-rate-limit (PIM view)

Table of Contents

Other manuals for HP 5900 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5900 series and is the answer not in the manual?

HP 5900 series Specifications

General IconGeneral
Ports48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity1.28 Tbps
MAC Address Table Size128K
Routing ProtocolsRIP, OSPF, BGP, IS-IS
VLAN Support4K VLANs
Dimensions440 x 460 x 44 mm
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% (noncondensing)

Related product manuals