HP 5900 series - Igmp Startup-Query-Interval

For an interface, the igmp startup-query-count command takes priority over the startup-query-count
command in IGMP view.
Examples
# Set the IGMP startup query count to 5 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp startup-query-count 5
Related commands
startup-query-count (IGMP view)
igmp startup-query-interval
Use igmp startup-query-interval to set the IGMP startup query interval on an interface.
Use undo igmp startup-query-interval to restore the default.
Syntax
igmp startup-query-interval interval
undo igmp startup-query-interval
Default
The IGMP startup query interval equals one quarter of the IGMP general query interval.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Sets an IGMP startup query interval in the range of 1 to 31744 seconds.
Usage guidelines
This command and the startup-query-interval command in IGMP view have the same function but
different effective ranges:
• The startup-query-interval command in IGMP view takes effect on all interfaces.
• The igmp startup-query-interval command takes effect on the current interface.
For an interface, the igmp startup-query-interval command takes priority over the startup-query-interval
command in IGMP view.
Examples
# Set the IGMP startup query interval to 100 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp startup-query-interval 100
Related commands
startup-query-interval (IGMP view)
101