Syntax
c-bsr ipv6-address [ scope scope-id ] [ hash-length hash-length | priority priority ] *
undo c-bsr ipv6-address [ scope scope-id ]
Default
No C-BSR is configured.
Views
IPv6 PIM view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the IPv6 address of a C-BSR.
scope scope-id: Specifies the ID of an IPv6 admin-scoped zone, in the range of 3 to 15. If you do not
specify an admin-scoped zone, the command designates the C-BSR to the global-scoped zone.
hash-length hash-length: Specifies a hash mask length in the range of 0 to 128. The default setting is
126 .
priority priority: Sets a C-BSR priority in the range of 0 to 255. The default setting is 64. A larger value
represents a higher priority.
Usage guidelines
The IPv6 address of a C-BSR must be the IPv6 address of a local IPv6 PIM enabled interface on the C-BSR.
Otherwise, the configuration does not take effect.
If you execute this command for a zone multiple times, the most recent configuration takes effect.
You can configure the same C-BSR for different zones.
Examples
# On the public network, configure the interface with the IPv6 address of 1101::1 as the C-BSR for the
global-scoped zone.
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] c-bsr 1101::1
c-rp (IPv6 PIM view)
Use c-rp to configure a candidate-RP (C-RP).
Use undo c-rp to remove the configuration of a C-RP.
Syntax
c-rp ipv6-address [ advertisement-interval adv-interval | { group-policy acl6-number | scope scope-id }
| holdtime hold-time | priority priority ] * [ bidir ]
undo c-rp ipv6-address
Default
No C-RPs are configured.
302
To Next Page
Loading...
