HP 5900 series Command Reference

Usage guidelines
If the IPv6 multicast address is in the SSM multicast address range, you must specify an IPv6 multicast
source address at the same time. Otherwise IPv6 multicast routing entries cannot be established. This
restriction does not exist if the specified IPv6 multicast group address is not in the SSM multicast address
range.
Examples
# Configure VLAN-interface 100 as a static group member of the IPv6 multicast group FF03::101.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld static-group ff03::101
# Configure VLAN-interface 100 as a static group member of the multicast source and group (2001::101,
FF3E::202).
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld static-group ff3e::202 source 2001::101
mld version
Use mld version to specify an MLD version for an interface.
Use undo mld version to restore the default.
Syntax
mld version version-number
undo mld version
Default
The MLD version is 1.
Views
Interface view
Predefined user roles
network-admin
Parameters
version-number: Specifies an MLD version, 1 or 2.
Examples
# Specify MLD version 2 for VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld version 2
other-querier-present-timeout (MLD view)
Use other-querier-present-timeout to set the global MLD other querier present timer.
Use undo other-querier-present-timeout to restore the default.
292

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)