HP 5900 series Command Reference

Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vlan vlan-id: Specifies a VLAN by its VLAN ID in the range of 1 to 4094.
slot slot-number: Specifies an IRF member device by its member ID or a PEX by its virtual slot number. If
you do not specify this option, the command displays static router port information on the master device.
Examples
# Display static router port information for VLAN 2.
<Sysname> display igmp-snooping static-router-port vlan 2
VLAN 2:
Router slots (0 in total):
Router ports (2 in total):
XGE1/0/1
XGE1/0/2
Table 5 Command output
Field Descri
p
tion
VLAN 2 VLAN ID.
Router slots (0 in total)
Member IDs of the member devices that have router ports and the total number of
the member devices (excluding the specified member device).
Router ports (2 in total) Static router ports, and the total number of the static router ports.
display igmp-snooping statistics
Use display igmp-snooping statistics to display statistics for the IGMP messages and PIMv2 hello
messages learned through IGMP snooping.
Syntax
display igmp-snooping statistics
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display statistics for the IGMP messages and PIMv2 hello messages learned through IGMP snooping.
<Sysname> display igmp-snooping statistics
Received IGMP general queries: 0
Received IGMPv1 reports: 0
7

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)