HP 5900 series Command Reference

You can configure multiple static RPs by using this command multiple times. However, if you specify the
Examples
f 2001::2 as a static RP for the
and give priority to this static RP.
w
cl6-basic-2001] rule permit source ff03::101 64
01] quit
[Sysname] ipv6 pim
001 preferred
t the global hello interval.
llo to restore the default.
undo timer hello
Default
lo interval is 30 seconds.
Views
PIM view
Predefine
elines
r the current interface in interface
onfiguration made in IPv6 PIM
Examples
bal hello interval to 40 seconds on the public network.
iew
[Sysname] ipv6 pim
[Sysname-pim6] timer hello 40
same static RP address or reference the same ACL in the commands, the most recent configuration takes
effect. If you configure multiple static RPs for the same IPv6 multicast group, the static RP with the highest
IPv6 address is used.
# On the public network, configure the interface with the IPv6 address o
IPv6 multicast groups FF03::101/64,
<Sysname> system-vie
[Sysname] acl ipv6 number 2001
[Sysname-a
[Sysname-acl6-basic-20
[Sysname-pim6] static-rp 2001::2 2
Related commands
display ipv6 pim rp-info
timer hello (IPv6 PIM view)
Use timer hello to se
Use undo timer he
Syntax
timer hello interval
The global hel
IPv6
d user roles
network-admin
Parameters
interval: Sets a hello interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds, the
interface does not send hello messages.
Usage guid
You can set the hello interval for all interfaces in IPv6 PIM view or fo
face view takes priority over the cview. The configuration made in inter
view.
# Set the glo
<Sysname> system-v
345

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)