HP 5900 series Command Reference

149
Predefined user roles
network-admin
Usage guidelines
This command takes effect only when PIM-DM or PIM-SM is enabled on the interface.
Examples
# On the public network, enable IP multicast routing. Then, enable PIM-DM and PIM passive mode on
VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] quit
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim dm
[Sysname-Vlan-interface100] pim passive
pim require-genid
Use pim require-genid to enable dropping hello messages without the generation ID options.
Use undo pim require-genid to restore the default.
Syntax
pim require-genid
undo pim require-genid
Default
Hello messages without the generation ID options are accepted.
Views
Interface view
Predefined user roles
network-admin
Examples
# Enable VLAN-interface 100 to drop hello messages without the generation ID options.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim require-genid
pim sm
Use pim sm to enable PIM-SM.
Use undo pim sm to disable PIM-SM.
Syntax
pim sm
undo pim sm

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)