Multicast routing and forwarding commands
The term "interface" in this chapter collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.
You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see
Layer 2—LAN Switching Configuration Guide).
delete ip rpf-route-static
Use delete ip rpf-route-static to delete static multicast routes.
Syntax
delete ip rpf-route-static [ vpn-instance vpn-instance-name ]
Views
System view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command deletes static multicast routes
on the public network.
Usage guidelines
This command deletes static multicast routes, but the undo ip rpf-route-static command deletes a specific
static multicast route.
Examples
# Delete all static multicast routes on the public network.
<Sysname> system-view
[Sysname] delete ip rpf-route-static
This will erase all multicast static routes and their configurations, you must reconfigure
all static routes.
Are you sure?[Y/N]:y
Related commands
ip rpf-route-static
display mac-address multicast
Use display mac-address multicast to display static multicast MAC address entries.
Syntax
display mac-address [ mac-address [ vlan vlan-id ] | [ multicast ] [ vlan vlan-id ] [ count ] ]
Views
Any view
63
To Next Page
Loading...
Need help?
General
