HP 5900 series Command Reference

Default
The IPv6 multicast group replacement feature is disabled on a port.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by its
ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The value range for the VLAN ID is 1
to 4094. If you do not specify a VLAN, the command applies to all VLANs.
Usage guidelines
This command takes effect only on the IPv6 multicast groups that a port dynamically joins.
This command and the overflow-replace command in MLD-snooping view have the same feature but
different effective ranges:
• The overflow-replace command in MLD-snooping view takes effect on all ports.
• The mld-snooping overflow-replace command takes effect on the current port.
For a port, the mld-snooping overflow-replace command takes priority over the overflow-replace
command in MLD-snooping view.
Examples
# Enable the IPv6 multicast group replacement feature for VLAN 2 on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mld-snooping overflow-replace vlan 2
Related commands
overflow-replace (MLD-snooping view)
mld-snooping querier
Use mld-snooping querier to enable the MLD snooping querier for a VLAN.
Use undo mld-snooping querier to disable the MLD snooping querier.
Syntax
mld-snooping querier
undo mld-snooping querier
Default
The MLD snooping querier for a VLAN is disabled.
Views
VLAN view
Predefined user roles
network-admin
224

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)