HP 5900 series Command Reference

Views
MRIB view
Predefined user roles
network-admin
Parameters
source: Specifies load splitting on a per-source basis.
source-group: Specifies load splitting both on a per-source basis and on a per-group basis.
Usage guidelines
This command does not take effect on BIDIR-PIM.
Examples
# Enable load splitting of multicast traffic on a per-source basis on the public network.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] load-splitting source
longest-match (MRIB view)
Use longest-match to specify the longest prefix match principle for RPF route selection.
Use undo longest-match to restore the default.
Syntax
longest-match
undo longest-match
Default
Route preference is used for RPF route selection
Views
MRIB view
Predefined user roles
network-admin
Examples
# Specify the longest prefix match principle for RPF route selection on the public network.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] multicast longest-match
mac-address multicast
Use mac-address multicast to configure a static multicast MAC address entry.
Use undo mac-address multicast to delete a static multicast MAC address entry.
79

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)