HP 5900 series Command Reference

mld non-stop-routing
Use mld non-stop-routing to enable MLD NSR.
Use undo mld non-stop-routing to disable MLD NSR.
Syntax
mld non-stop-routing
undo mld non-stop-routing
Default
MLD NSR is disabled.
Views
System view
Predefined user roles
network-admin
Examples
# Enable MLD NSR.
<Sysname> system-view
[Sysname] mld non-stop-routing
mld other-querier-present-timeout
Use mld other-querier-present-timeout to set the MLD other querier present timer on an interface.
Use undo mld other-querier-present-timeout to restore the default.
Syntax
mld other-querier-present-timeout time
undo mld other-querier-present-timeout
Default
The MLD other querier present timer is calculated by the following formula:
[ MLD general query interval ] × [ MLD querier's robustness variable ] + [ maximum response time for
MLD general queries ] / 2.
Views
Interface view
Predefined user roles
network-admin
Parameters
time: Sets an MLD other querier present timer in the range of 1 to 31744 seconds.
Usage guidelines
This command and the other-querier-present-timer command have the same function but different
effective ranges:
287

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)