To Next Page

To Previous Page

mld-snooping general-query source-ip

Use mld-snooping general-query source-ip to configure a source IPv6 address for MLD general queries.

Use undo mld-snooping general-query source-ip to restore the default.

Syntax

mld-snooping general-query source-ip ipv6-address

undo mld-snooping general-query source-ip

Default

The source IPv6 address for MLD general queries is the IPv6 link-local address of the current VLAN

interface. If the current VLAN interface does not have an IPv6 link-local address, the source IPv6 address

is FE80::02FF:FFFF:FE00:0001.

Views

VLAN view

Predefined user roles

network-admin

Parameters

ipv6-address: Specifies a source IPv6 address for MLD general queries.

Usage guidelines

You must enable MLD snooping for a VLAN before you execute this command for the VLAN.

Examples

# In VLAN 2, enable MLD snooping, and configure FE80:0:0:1::1 as the source IPv6 address of MLD

general queries.

<Sysname> system-view

[Sysname] mld-snooping

[Sysname-mld-snooping] quit

[Sysname] vlan 2

[Sysname-vlan2] mld-snooping enable

[Sysname-vlan2] mld-snooping general-query source-ip fe80:0:0:1::1

Related commands

• enable (MLD-snooping view)

• mld-snooping enable

mld-snooping group-limit

Use mld-snooping group-limit to set the maximum number of IPv6 multicast groups that a port can join.

Use undo mld-snooping group-limit to restore the default.

Syntax

mld-snooping group-limit limit [ vlan vlan-list ]

undo mld-snooping group-limit [ vlan vlan-list ]

217

Other manuals for HP 5900 series

Questions and Answers:

Need help?

Do you have a question about the HP 5900 series and is the answer not in the manual?

General