Parameters
version-number: Specifies an MLD snooping version, 1 or 2.
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command.
This command and the version command in MLD-snooping view have the same function but different
effective ranges:
• The version command in MLD-snooping view takes effect on the specified VLANs.
• The mld-snooping version command takes effect on the current VLAN.
For a VLAN, the mld-snooping version command and the version command in MLD-snooping view have
the same priority, and the most recent configuration takes effect.
Examples
# In VLAN 2, enable MLD snooping, and specify MLD snooping version 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2
Related commands
• enable (MLD-snooping view)
• mld-snooping enable
• version (MLD-snooping view)
overflow-replace (MLD-snooping view)
Use overflow-replace to enable the IPv6 multicast group replacement feature globally.
Use undo overflow-replace to disable the IPv6 multicast group replacement feature globally.
Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
Default
The IPv6 multicast group replacement feature is disabled globally.
Views
MLD-snooping view
Predefined user roles
network-admin
Parameters
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by its
ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The value range for the VLAN ID is 1
to 4094. If you do not specify a VLAN, the command applies to all VLANs.
232
To Next Page
Loading...
