Table 74 Command output
Field Descri
tion
Interface Interface name.
Index Index number of the interface.
Current state Current status of the interface: up or down.
MTU MTU value.
Type
Interface type:
• BROADCAST—Broadcast link interface.
• LOOP—Loopback interface.
• REGISTER—Register interface.
• NBMA—NBMA interface.
• MTUNNEL—Multicast tunnel interface.
Protocol Protocol running on the interface: PIM-DM, PIM-SM, or MLD.
PIM protocol state
Whether IPv6 PIM is enabled:
• Enabled
• Disabled
Address list Interface address list.
Local address Local IP address.
Remote address Remote end IP address. This field is displayed when the interface is vlink type.
Reference Number of times that the address has been referenced.
State Status of the interface address: NORMAL or DEL.
display ipv6 multicast boundary
Use display ipv6 multicast boundary to display IPv6 multicast boundary information.
Syntax
display ipv6 multicast [ vpn-instance vpn-instance-name ] boundary { group [ ipv6-group-address
[ prefix-length ] ] | scope [ scope-id ] } [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command displays IPv6 multicast
boundary information on the public network.
group: Displays the IPv6 multicast boundary information for the specified group.
256
To Next Page
Loading...
Need help?
General
