vlan vlan-id: Specifies a VLAN by its VLAN ID in the range of 1 to 4094. If you do not specify a VLAN,
the command displays Layer 2 IPv6 multicast group entries for all VLANs.
slot slot-number: Specifies an IRF member device by its member ID or a PEX by its virtual slot number. If
you do not specify this option, the command displays Layer 2 IPv6 multicast group entries on the master
device.
Examples
# Display Layer 2 IPv6 multicast group entries for VLAN 2.
<Sysname> display ipv6 l2-multicast ip forwarding vlan 2
Total 1 entries.
VLAN 2: Total 1 IP entries.
(::, FF1E::101)
Host slots (0 in total):
Host ports (3 in total):
XGE1/0/1
XGE1/0/2
XGE1/0/3
Table 56 Command output
Field Descri
tion
Total 1 entries Total number of Layer 2 IPv6 multicast group entries.
VLAN 2: Total 1 IP entries Total number of Layer 2 IPv6 multicast group entries in VLAN 2.
(::, FF1E::101)
(S, G) entry, where a double colon (::) in the S position means any IPv6
multicast sources.
Host slots (0 in total)
Member IDs of the member devices that have member ports and the total
number of the member devices (excluding the specified member device).
Host ports (3 in total) Member ports, and the total number of the member ports.
display ipv6 l2-multicast mac
Use display ipv6 l2-multicast mac to display information about Layer 2 IPv6 MAC multicast groups.
Syntax
display ipv6 l2-multicast mac [ mac-address ] [ vlan vlan-id ] [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
mac-address: Specifies an IPv6 MAC multicast group by its IPv6 MAC address. If you do not specify an
IPv6 MAC multicast group, the command displays information about all Layer 2 IPv6 MAC multicast
groups.
195
To Next Page
Loading...
Need help?
General
