[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface ten-gigabitethernet 1/0/1
ping host-join 232.1.1.1 source-ip 1.1.1.1
-snooping last-member-query-interval
-query-interval to set the IGMP last member query interval for a VLAN.
Use undo igmp-snooping last-member-query-interval to restore the default.
Syntax
g last-member-query-interval interval
ember-query-interval
Predefine
Paramete
Usage guide
s in a VLAN.
u must enable IGMP snooping for a VLAN before you execute this command for the VLAN.
me
ve ranges:
interval command in IGMP-snooping view takes effect on all VLANs.
er-query-interval command takes effect on the current VLAN.
mber-query-interval command takes priority over the
g, and set the IGMP last member query interval to 3 seconds.
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping last-member-query-interval 3
[Sysname-Ten-GigabitEthernet1/0/1] igmp-snoo
vlan 2
igmp
Use igmp-snooping last-member
igmp-snoopin
undo igmp-sn
Default
ooping last-m
The default
Views
setting is 1 second.
VLAN view
d user roles
network-admin
rs
interval: Sets an IGMP last member query interval in the range of 1 to 25 seconds.
lines
The IGMP last member query interval determines the interval for sending IGMP group-specific queries
and the maximum response time for IGMP group-specific querie
Yo
This command and the last-member-query-interval command in IGMP-snooping view have the sa
function but different effecti
• The last-member-query-
• The igmp-snooping last-memb
For a VLAN, the igmp-snooping last-me
last-member-query-interval command in IGMP-snooping view.
Examples
# In VLAN 2, enable IGMP snoopin
<Sysname> system-view
[Sysname] igmp-snooping
27
To Next Page
Loading...
Need help?
General
