HP 5900 series Command Reference

Paramete
ecifies IPv6 multicast load splitting on a per-source basis.
a per-source basis and on a per-group basis.
elines
Examples
on a per-source basis on the public network.
longe
Use longest-match to specify the longest prefix match principle for RPF route selection.
h to restore the default.
Syntax
longest-match
is used for RPF route selection.
user roles
Examples
iple for RPF route selection on the public network.
reset
st forwarding events.
ulticast [ vpn-instance vpn-instance-name ] forwarding event
Predefined user roles
network-admin
rs
source: Sp
source-group: Specifies IPv6 multicast load splitting on
Usage guid
This command does not take effect on IPv6 BIDIR-PIM.
# Enable load splitting of IPv6 multicast traffic
<Sysname> system-view
[Sysname] ipv6 multicast routing
[Sysname-mrib6] load-splitting source
st-match (IPv6 MRIB view)
Use undo longest-matc
undo longest-match
Default
Route preference
Views
IPv6 MRIB view
Predefined
network-admin
# Specify the longest prefix match p
<Sysname> system-view
rinc
[Sysname] ipv6 multicast routing
[Sysname-mrib6] longest-match
ipv6 multicast forwarding event
Use reset ipv6 multicast forwarding event to clear statistics for IPv6 multica
Syntax
reset ipv6 m
Views
User view
270

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)