MLD snooping commands
display ipv6 l2-multicast ip
Use display ipv6 l2-multicast ip to display information about Layer 2 IPv6 multicast groups.
Syntax
display ipv6 l2-multicast ip [ group ipv6-group-address | source ipv6-source-address ] * [ vlan vlan-id ]
[ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group ipv6-group-address: Specifies an IPv6 multicast group by its IPv6 address. If you do not specify an
IPv6 multicast group, the command displays information about all Layer 2 IPv6 multicast groups.
source ipv6-source-address: Specifies an IPv6 multicast source by its IPv6 address. If you do not specify
an IPv6 multicast source, the command displays information about Layer 2 IPv6 multicast groups for all
IPv6 multicast sources.
vlan vlan-id: Specifies a VLAN by its VLAN ID in the range of 1 to 4094. If you do not specify a VLAN,
the command displays information about Layer 2 IPv6 multicast groups for all VLANs.
slot slot-number: Specifies an IRF member device by its member ID or a PEX by its virtual slot number. If
you do not specify this option, the command displays information about the Layer 2 IPv6 multicast groups
on the master device.
Examples
# Display information about the Layer 2 IPv6 multicast groups for VLAN 2.
<Sysname> display ipv6 l2-multicast ip vlan 2
Total 1 entries.
VLAN 2: Total 1 IP entries.
(::, FF1E::101)
Attribute: static, success
Host slots (0 in total):
Host ports (1 in total):
XGE1/0/1 (S, SUC)
Table 55 Command output
Field Descri
tion
Total 1 entries Total number of Layer 2 IPv6 multicast groups.
193
To Next Page
Loading...
Need help?
General
