<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping host-aging-time 300
Related c
• host-aging-time (IGMP-snooping view)
-snooping host-join
ping host-join to configure a port as a simulated member host for a multicast group.
snooping host-join to remove the simulated joining configuration.
Default
Views
er 2 aggregate interface view
les
Paramete
urce-ip source-address: Specifies a multicast source by its IP address. If you specify a multicast source,
kes effect on IGMPv3 snooping devices.
by its VLAN ID in the range of 1 to 4094.
Usage gu
as a simulated member host ages out like a dynamic
simulated member host runs must be the same.
Examples
# Configure Ten-GigabitEthernet 1/0/1 as a simulated member host of the multicast source and group
(1.1.1.1, 232 .1.1.1) i n V L A N 2 .
<Sysname> system-view
[Sysname] igmp-snooping
ommands
• enable (IGMP-snooping view)
• igmp-snooping enable
igmp
Use igmp-snoo
Use undo igmp-
Syntax
igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping host-join { group-address [ source-ip source-address ] vlan vlan-id | all }
A port is not configured as a simulated member host for multicast groups.
Layer 2 Ethernet interface view, Lay
Predefined user ro
network-admin
rs
group-address: Specifies a multicast group in the range of 224.0.1.0 to 239.255.255.255.
so
the command configures the port as a simulated member host for a multicast source and group. If you do
not specify a multicast source, the command configures the port as a simulated member host for a
multicast group. This option ta
vlan vlan-id: Specifies a VLAN
all: Specifies all multicast groups.
idelines
Unlike a static member port, a port configured
member port.
The IGMP version and IGMP snooping version that the
26
To Next Page
Loading...
Need help?
General
