HP 5900 series Command Reference

• router-aging-time (IGMP-snooping view)
igmp-
ing a dynamic router port.
Use undo igmp-snooping router-port-deny to restore the default.
Syntax
undo igmp-snooping router-port-deny [ vlan vlan-list ]
Default
A port can become a dynamic router port.
Views
et interface view, Layer 2 aggregate interface view
Predefine
ork-admin
Paramete
94. If you specify VLANs, the command takes effect only when the port belongs to the specified
ANs. If you do not specify a VLAN, the command takes effect on all VLANs to which the port belongs.
Examples
dynamic router port in VLAN 2.
[Sysname] interface ten-gigabitethernet 1/0/1
igmp-snooping router-port-deny vlan 2
igmp-
card all the
Use undo igmp-snooping source-deny to disable multicast source port filtering on a port.
Syntax
undo igmp-snooping source-deny
Default
Multicast source port filtering is disabled, and the port can connect to both multicast sources and
multicast receivers.
Views
et interface view
snooping router-port-deny
Use igmp-snooping router-port-deny to disable a port from becom
igmp-snooping router-port-deny [ vlan vlan-list ]
Layer 2 Ethern
d user roles
netw
rs
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by its
ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The VLAN ID is in the range of 1 to
40
VL
# Disable Ten-GigabitEthernet 1/0/1 from becoming a
<Sysname> system-view
[Sysname-Ten-GigabitEthernet1/0/1]
snooping source-deny
Use igmp-snooping source-deny to enable multicast source port filtering on a port to dis
received multicast data packets.
igmp-snooping source-deny
Layer 2 Ethern
34

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)